“Whoever controls alien technology rules the world.” –
Stanton Friedman, Nuclear Physicist
0.5: Victor Grebennikov: From Honeycomb To Cavity Structural Effect
The Russian entomologist Viktor S. Grebennikov claimed that he built an anti-gravity platform using his Cavity Structural Effect (CSE) principles in shaping the chitin of some large flying beetles which should have been aerodynamically incapable of flying.
As usually, this discovery was made by chance. Once Grebennikov put a chitin bristle from some beetle’s shell under a microscope and wanted to put another one but it slipped out from tweezers and… hung in the air. Then the scientist tied some laminae together from the top by a wire arranging them vertically. Grebennikov discovered a bio antigravity effect in 1988 and then, during 3 years, studied it from many sides, developed the platform’s designs, carried out experiments. Together with Professor V. Zolotarev, he sent a patent application. Finally, in 1991, Grebennikov built his gravity plane and started flying by a noiseless aircraft, which reached a speed of 1,500-2,400 km/hour. The aircraft was inertia less and almost invisible from below. People, who observed it from ground, saw, instead of it, a light sphere or a disc or a cloud with sharply outlined edges.
Grebennikov studied an effect of cavitary structures of insects. He gave this name to a mysterious radiation emanated from their nests. In chapter 5, of his book; My World Grebennikov said: “I have only a handful of old clay lumps, fragments of these nests, with numerous small rooms’ cells. The cells were located side by side and looked like small thimbles or, more likely, small jugs with smoothly narrowing beaks. I have already known that these bees belonged to species of Halictus – according to the number of light rings on their oblong bellies. There was a wide vessel filled with these spongy clay lumps on my working table, which was jammed with instruments, ant and grasshopper houses, vials with chemical agents and other things. I had to take something and I brought my hand above these spongy fragments. And a miracle happened: I suddenly felt heat above them… I touched the lumps by the hand – they were cold. But I obviously felt heat above them. Moreover, I felt unknown pushes, bounce, and ‘tick in my fingers’.”
This radiation cannot be screened. Grebennikov wrote: “I put a piece of cardboard on top – the feelings were the same. I put a pan’s lid but it had no effect: this “something” ran through the barrier. I should immediately study this phenomenon. But the instruments did not react at all: neither finest thermometers, nor ultrasound recorders, electrometers nor magnetometers. But usual human hands (and not only mine hands!) obviously felt either heat or cold wind or ticks or a denser medium above the nests. Some people’s hands became heavier, other people’s hands were pushed up; some people’s fingers grew numb, fore arm’s muscles felt spasms, some people felt giddy, secreted saliva voluminously.”
But how did V. Grebennikov came to the idea of his aircraft? Let us read further: “In summer
1988, I watched by microscope chitin shells of insects, their fleecy antennae, butterfly wings’ lamellae of finest structure, open work of shad mooneye’s wings with bright play and other Natural Patents. I was interested in an unusually rhythmic microstructure of some parts of rather big insects. This was an extremely ordered composition, which looked as if it had been pressed by some complicated automatic machine according to special designs and calculations. In my opinion, this incomparable cellular structure was necessary neither for strength nor for decoration of this part. And, in two years of laborious work, a gravity plane, an aircraft with amazing characteristics. It is invisible, need no traditional engine as we imagine it, and has no wings or a propeller. It is noiseless; easily reach a safe flight speed of 1500 km/h, which is not felt by a pilot: there are no either inertia properties of a moving body or heat influence of the environmental air to the aircraft, or dynamic pressure or other effects. It also has a very simple design: a post with two handles placed on an opened platform.”
The Cavity Structure Effect
Which is a physical nature of the cavity structures effect? Many suppositions and hypothesis have been expressed but, unfortunately, many of them are connected with extrasensory perception, which is fashionable among modern intellectuals for some reasons. A theory of Leningrad physician, Doctor of Technical Science, V.F. Zolotarev deserves better attention. It was developed by him earlier and experimentally confirmed now. As a result of long combined researches, we characterized the discovery as “an unknown effect of multicavitary structures’ interaction with living systems consisting in that, due to interference, de Broglie waves accompanying motion of electron flows in solid walls of cavities form a macroscopic field of multi-cavity structures, which cause change of functional state of living objects locating in this field”. De Broglie waves are peculiar to moving micro particles of any body. They are compensated inside the body and displayed as radiation on its surface. They are so shortwave and super highfrequency that instruments pick them up only in the form of diffraction but still they helped science. Remember peculiar pictures of electrons and neutrons obtained on crystals and films with the help of de Broglie waves.
Nobody thought that these scanty radiations can influence living matter somehow. And they did not influence – at least near flat objects. But near multicavitary structures, where a square of solid bodies is big and multiply curved, de Broglie waves are put together and form, like musical overtones, harmonies with lower frequencies. Thus, lengthening and strengthening due to laying on ach other in cells, they form antinodesmaximums of stationary de Broglie waves. Striking on these passive barriers, nerve impulses glitch changing their frequency and speed and causing not only seeming feelings but also sometimes considerable physiological changes. Stationary de Broglie waves do not have their own energy and, therefore, the law of energy conservation is not violated. Due to the fact that de Broglie waves moves in physical vacuum, the effect of cavitary structures must permeate everything. We observe it when we uselessly try to stop the effect up by any screen.
0.6: Wilhelm Reich: Ether Physics And The Energy Fields Of Geometrical Forms
Works of Wilhelm Reich are also connected with change ether density. We would like to express some interesting thoughts: “Energy fields of geometrical forms” are special effects connected with the modern concept of ether. Some optimal geometrical forms and materials can be used for constructing devices, which react under influence of only environmental conditions, i.e. without additional external stimulation. Contraction details of two simple devices, which produce a tangible linear force influence without use of any additional energy at the input. It is possible to note two meanings of these training demonstration devices:
1- They prove that an etheric kind of matter exists and any average person can feel it;
2- They demonstrate reliable methods of etheric activation, which can be used for new energy applications.
Other examples of devices with efficiency more than one include a venerable organpipe and an electromagnetic antenna. These devices work using resonance method when relatively low vibration of amplitude is reflected back. An echo signal can be many times more than an input signal in dependence on sizes of the device. The most effective size of the resonator accurately corresponds with a quarter of the initial wave length. Resonance will also occur with any lengths which are divisible by an odd number of a quarter of waves’ lengths. In these cases, we find that geometry of the specific device has minor significance. If the geometry is optimized for conditions at the input, a maximal increase or an increased echo can be obtained. We can summarize characteristics of these “supersingle” devices as devices using “geometrical energy fields” because intensity of full energy of echo, which can be produced only as a function of size, form and location.
We can suppose that certain highly optimized geometrical forms could provide for an increased echo without any additional input signal at all. Such a device could induce an effective echo increasing the finest vibrations at quantum level, which are much lower than the threshold our ability to measure them. Despite the fact that the subtlest natural forces have been studied for thousands years, it can be proved that a modern era began in 1844. In 1844, Baron Karl von Reichenbach from Stuttgart published a series of letters describing his research of ether, which was called “OD” by him. Reichenbach discovered that a part of all people can visually feel outflow from tops of crystals and magnets if they had been first properly located in full darkness. He called such people “sensitives”.
Later, Reichenbach decided that ether can permeate through materials like silk, glass and metal. According to his ideas, ether seems to permeate all things in different density. Large quantities of ether could be found in sunlight and candle flame. On the edge of the century, an Austrian philosopher Rudolf Steiner with clairvoyance talent researched an invisible world of etheric forces. His close partner and biographer Guenther Wachsmith continued this work after Steiner’s death and published a masterwork of his teacher called “Etheric shaping forces in Space, Earth and Man”. A first true engineer of etheric forces was Wilhelm Reich who discovered, as he called it, “orgone energy” in 1939. Like Reichenbach, Reich discovered that metals able to conduct ether a hundred years ago. His real big achievement, however, was an understanding of the fact that organic materials have a tendency to absorb ether. Laying two kinds of materials together, Reich could produce a directed ether flow. Reich developed a first working device for collection and concentration of ether. An “orgone accumulator” is a box with six walls made of alternating layers of metal and organic materials. Under controlled conditions, this device produced an inexplicable temperature increase in its internal part. This was enough for attracting attention of Albert Einstein who met Reich in January 1941.
Reich also experimented with a “cloud-buster” (a buster for clouds dispersion), a tower shaped device which, most likely, directed an ether flow through atmosphere. Possible, the biggest contribution to ether engineering technologies was made by Trevor James Constable. He was a follower of Steiner, Wachsmith, Reich and others. He spent more than 40 years improving use of the ether technology of weather control. He discovered that some geometrical forms, possibly, show a big ether echo. During many years, he developed his methods so that a device with a size of a coffee mug located, accordingly, far from an ocean ship could change weather condition over a distance of many miles around it. Constable discovery of resonance etheric structures was important for research of the new energy. Now a simple geometrical device can direct a concentrated beam of etheric forces through any type of a device with high accuracy. Actually, a degree of ether concentration is so high that human organs of senses can directly feel its resultant pressure. Thanks to pioneer works of the above mentioned scientists, it is possible to describe a design of two resonance ether devices, which were called “Chi Pencils” by the author.
Both devices are built around a central resonance cavity. A formula for calculation of the resonance cavity’s size was obtained from a research of a ballistics expert Gerald Bull from Philadelphia.
An “emitting” device is generally a cylindrical metal cavity with a nometal external layer. Due to boundary effects discovered by Reich, ether is absorbed from space through a side surface and emitted through both sides (actually, it is like laser). To build the emitting device following things are necessary:
– A piece of a 5/32 inches copper pipe
– A 1/8inches soft cotton cord
– A metal knife for the pipe
– A meterstick, a sharp knife and glue.
– A metal knife for the hose and the pipe
– A meter stick
– A sharp knife and electrical insulation tape.
Cut a piece of the copper pipe with a length of 18.1 cm. Apply a small bead of hot glue to the external part of one end and fix the cotton cord there. Wind 2 cm, apply a bead of hot glue and wind the cord around the entire pipe. Cut excess of the cord. A “vacuum” device is made the other way. We need a non-metal cylindrical cavity with a metal external layer. Ether is drawn into one end and dispersed through the sides. Cut a piece of the copper pipe with a length of 18.1 cm. Wind the electrical insulation tape around the vinyl hose in some places in such a way that it could closely go into the copper pipe. Push the vinyl hose into the copper pipe until its end appear. Cut excess of the vinyl hose. The noted streams of ether forces generated by above described different resonance devices allow defying their discovery by standard instruments. It is not surprising that, as many observers think, ether is “live” energy while standard instruments are, of course, “dead”. However, discovery of ether forces by a living organism such as a human body is known.
To be continued
Reposts are welcomed with the reference to ORIENTAL REVIEW.
Comments